#!/usr/bin/perl
#
# This program takes one or more .set files, and chooses the nth
# resolution listed as the default resolution.  Resolutions above
# that are not preloaded.

if ($#ARGV < 1 || substr($ARGV[0], 0, 1) eq "-") {
    print STDERR "\n";
    print STDERR "Usage: plysetlevel n 1.set 2.set 3.set ...\n";
    print STDERR "\n";
    print STDERR "       where n is an integer, usually from 1 to 4,\n";
    print STDERR "       and is the desired level.  So it will set the\n";
    print STDERR "       nth mesh in each .set file to be the default,\n";
    print STDERR "       and all higher-res meshes will not be preloaded.\n";
    print STDERR "       e.g:\n";
    print STDERR "             plysetlevel 2 *.set\n";
    print STDERR "       will tell every set to load in meshes 2..4,\n";
    print STDERR "       and make mesh 2 the default.\n";
    exit(-1);
}

# Default level
$level = int($ARGV[0]);
($level > 0) || die "Error: level must be greater than 0\n";

# Process the files one by one
for ($i=1; $i <= $#ARGV; $i++) {
    $set = $ARGV[$i];
    (substr($set, -4, 4) eq ".set") || die 
	"Err: $set does not have .set extension.  Aborting...\n";
    open(IN, $set);

    # Read 'NumMeshes = 4'
    $line = <IN>;
    @words = split(' ', $line);
    $nummeshes = $words[2];
    # Sanity check
    ($level > 0 && $nummeshes >= $level) || die 
	"Error: $set doesn't have $level levels!\n";
    
    # Skip 'DefaultRes = 650006'
    $line = <IN>;

    # Read each of the meshes
    for ($m=1; $m <= $nummeshes; $m++) {
	$line = <IN>;
	@words = split(' ', $line);
	# Save mesh size, name
	$meshsize[$m] = $words[1];
	$meshname[$m] = $words[2];
    }
    
    # Close file, open again for writing
    close(IN);
    open(OUT, ">".$set);
    
    # Write out new file
    print OUT "NumMeshes = $nummeshes\n";
    print OUT "DefaultRes = $meshsize[$level]\n";
    # Write each mesh, noloading meshes higher than new default size
    for ($m=1; $m <= $nummeshes; $m++) {
	if ($m < $level) { 
	    print OUT "noload  $meshsize[$m] $meshname[$m]\n";
	} else {
	    print OUT "preload $meshsize[$m] $meshname[$m]\n";
	}
    }
    close(OUT);
}